Hi everyone,
Today I waned to share with you how to make a snowflake from pipe cleaners/fuzzy sticks. The snowflake is very easy to make and you don’t need to be super crafty to make it. “Thumbs up” on youtube if you like it, and subscribe (again on my youtube channel) if you want to see more. I am going to write down the instructions for you bellow, and share my youtube channel link also at the end of the post :).
DIY how to make a snowflake from pipe cleaners/fuzzy stics
1.Take a square piece of paper with the corner facing you. If you want a colored envelope, make sure the colored side is facing down.
2.Fold the paper in half, from corner to corner across the square.
3.Take the top corner of the first layer and fold it down to the bottom edge.
4.Fold the right corner one third over to the left. You do not have to be exact, just try to be as accurate as possible.
5.Take the left corner and fold it over to the other end. Now the bottom portion should be square shaped.
6.Fold the point of the flap over the other flap back to the left edge of the model.
7.Fold the point of the flap up to the top corner of the flap. Unfold. This is a crease to help guide the next step.
8.Turn the model 180 degrees. The point of view will now change.
9.Open the folded portion of the flap.
10.Make a squash fold on this flap. Make sure you flatten it well, as this will help secure the envelope closed.
11.Change the position back so it is “upright.” Or turn it back 180 degrees.
12.Fold the very top point down to the bottom edge. Or, the bottom edge of the square you formed by “squashing.”
13.Put the top flap (the portion you just folded down) into the “pocket” that was formed by the squash fold.
14.Flatten the model. Ensure that the model can hold itself together.
My youtube channel (Copy this) : http://www.youtube.com/channel/UC7d_SMfEhgul4K3Div8v5rA